ATTO Technology 1500D/E - Manual (Page 38)

29
ATTO Technology Inc. iPBridge Installation and Operation Manual
2.2.4 Maintenance commands
The CLI commands outlined in this chapter may be used to get information or perform functions which
are used in a variety of situations with the ATTO iPBridge.
FirmwareRestart
Causes the iPBridge to reboot, then re-initialize its
firmware.
Immediate command: FirmwareRestart
Password
RestoreConfiguration default sets the password to the
default value
Passwords are case sensitive, 0-32 characters with no
spaces
When the password is all 0s, Telnet and ftp do not validate
the password and MD5 authentication are disabled.
Default: Password
Set syntax: set Password
Requires a SaveConfiguration command
Reserve
Reservation of the iPBridge is implicit: once the
configuration image is changed by any user of services,
the iPBridge becomes RESERVED. Executing a
SaveConfiguration or\ Restore configuration RELEASES
the iPBridge so that other services users may access it.
When iPBridge services interface is RESERVED, set
commands from other users are unavailable.
At least one interface must always have access to the
iPBridge.
Immediate command: Reserve
RestoreConfiguration
Restores configuration to either the default configuration
or the configuration last saved into non-volatile memory.
The saved option will undo any changes made since the
last save.
Immediate command: RestoreConfiguration [Default |
Saved]
SCSIPortReset
Resets the specified SCSI bus.
Immediate command: SCSIPortReset [sb]
SpeedWrite
When enabled, improves the performance of FCP WRITE
commands to SCSI devices attached to the iPBridge.
Specify SCSI bus (sb), target (st), LUN (sl) of a mapped
SCSI device or (all) for each currently mapped device
Set syntax: set SpeedWrite SCSI [sb st sl | all]
[enabled|disabled]
Get syntax: get SpeedWrite SCSI [sb st sl|all]
SpeedWriteDefault
When enabled, SpeedWrite performance enhancement is
set as the default for any subsequent SCSI devices
mapped manually or via an AutoMap operation. If
disabled, the iPBridge will not attempt SpeedWrite
performance enhancement to newly-mapped SCSI
devices.
Default: disabled
Set syntax: set SpeedWriteDefault [enabled | disabled]
Get syntax: get SpeedWriteDefault
Username
Specifies username for all Telnet, FTP and ExpressNAV
web server sessions.The username is case insensitive, 1-
32 characters, no spaces You must have the Admin
password to change Username.
Default: root
Set syntax: set Username [username]
Requires a SaveConfiguration command
Get syntax: get Username