Sony MHC-GS200 - Manual (Page 12)

12 US
Adjusting the speaker volume
of each speaker
— Test tone
1
Press DOLBY PRO LOGIC (or PRO
LOGIC on the remote).
“DOLBY PL ON” appears.
2
Press TEST TONE on the remote.
The test tone is heard from the speakers in
the following order and the display changes
as in the parentheses.
Front left (LEFT) t Center (CENTER) t
Front right (RIGHT) t Rear (REAR) t
Front (LEFT) t …
3
From your listening position, adjust the
volume and balance by pressing the
buttons on the remote until the volume
level of the test tone from each speaker
sounds the same.
To adjust Press
the balance
between the front
left and front right
speakers
Setting the clock
1
Press =/1 to turn on the system.
2
Press TIMER SET.
3
Press . or > repeatedly to set the
hour.
4
Press ENTER.
5
Press . or > repeatedly to set the
minute.
6
Press ENTER.
To adjust the clock
1 Press TIMER SET.
2
Press . or > repeatedly to select
“CLOCK SET”, then press ENTER.
3
Do the same procedures as step 3 to 6
above.
Notes
• The clock settings are canceled when you
disconnect the power cord or if a power failure
occurs.
• You cannot set the clock in Power Saving Mode.
BALANCE LEFT or
BALANCE RIGHT
repeatedly while “LEFT”,
“RIGHT” or “CENTER”
appears.
Setting up your speakers for Dolby
Pro Logic (continued)
the balance
between the rear
left and rear right
speakers BALANCE LEFT or
BALANCE RIGHT
repeatedly while “REAR”
appears.
the volume of the
center speaker CENTER + or CENTER –
repeatedly.
the volume of the
rear speakers REAR + or REAR –
repeatedly.
4
Press TEST TONE on the remote when
you finish adjusting.
The test tone turns off.
Note
The test tone feature works only for Dolby Pro Logic
Surround sound.