Sony MHC-GS200 - Manual (Page 25)

Tape
25 US
Recording a CD by specifying
track order
— Program Edit
When programing, make sure the playing times
for each side do not exceed the length of one
side of the tape.
1
Load a recordable tape into the deck.
2
Program CD tracks following step 1 to 6
in “Programing CD tracks” on page 15.
3
Press CD SYNC (or CD SYNC on the
remote
* ).
Tape stands by for recording and CD pauses
for play.
4
Press PLAY MODE/DIRECTION
repeatedly to select
g to record on
one side. Select h or j to record on
both sides.
5
Press REC z PAUSE/START (or X on
the remote).
Recording starts.
Tip
If you select both sides recording and the tape reaches
the end of the front side part-way through a track, the
entire track is recorded again from the beginning of
the reverse side.
Note
After step 3, you cannot pause a CD even if you press
PAUSE X (or X on the remote).
* MHC-GS200 only
Timer-recording radio
programs
You can record a preset radio station from a
specified time.
To timer-record, you must first preset the radio
station (see “Presetting radio stations” on
page 20) and set the clock (see “Setting the
clock” on page 12).
1
Tune in the preset radio station (see
“Listening to the radio” on page 22).
2
Press TIMER SET.
3
Press . or > repeatedly to select
“REC SET”, then press ENTER.
“ON” appears and the hour indication
flashes.
4
Set the time to start recording.
Press . or > repeatedly to set the
hour, then press ENTER.
The minute indication flashes.
Press . or > repeatedly to set the
minute, then press ENTER.
5
Set the time to stop recording following
the procedure in step 4.
The start time appears, followed by the stop
time, the preset radio station to be recorded
(e.g., “TUNER FM 5”), then the original
display appears.
6
Load a recordable tape into the deck.
7
Press ?/1 to turn off the system.
When the recording starts, the volume is
reduced to minimum.
continued