Sony PFM-42B2H - Manual (Page 67)

15
(GB)
Connections
Within 10 mm ( 13 /
32
inch)
Within 10 mm ( 13 / 32 inch)
When attaching to the cables
When you connect a cable to any of the terminals
listed below, attach the ferrite core provided before
using the cable.
AUDIO (INPUT1)
AUDIO (INPUT2)
AUDIO OUT
REMOTE
Y/C IN (VIDEO)
AUDIO IN (VIDEO)
1
Attach the ferrite core (black) to the end of the
cable closer to the PFM-42B2/42B2E, closing it
firmly until your hear it click.
2
Wind the stopper round the cord so that the ferrite
core does not slide.
3
Tighten the stopper and cut the surplus.
Notes
• When you connect this unit to various pieces of
equipment using the RGB/YUV connectors, use the
specified cable.
SMF-400 (D-Sub 15P - 5 BNC)
SMF-410 (D-Sub 15P - D-Sub 15P)
• You are cautioned that this unit will not be in
compliance with the EMC limits unless the ferrite
core is installed on the interconnecting wire.
Connection Example
Before you start
• First make sure that the power to each piece of
equipment is turned off.
• Use connecting cables suitable for the equipment to
be connected.
• The cable connectors should be fully inserted into
the jacks. A loose connection may cause hum and
other noise.
• To disconnect the cable, pull it out by grasping the
plug. Never pull the cable itself.
• Refer to the instruction manual of the equipment to
be connected.
• Insert the plug securely into the AC IN socket.
• Use one of the two AC plug holders (supplied) that
will securely hold the AC plug.