Sony PFM-42B2H - Manual (Page 86)

34
(GB)
Notes
• Dot phase adjustment is effective for computer
signals (except for UXGA and above).
• When noise can’t be eliminated using Adjusting
automatically, make fine Adjusting manually.
• A cross-hatch pattern is convenient for use as the
input signal when adjusting the dot phase.
• While you are adjusting PIXEL ADJUST, the value
displayed on the display panel is not synchronized
with the change.
Using the Memory
Function
You can save the current picture setting for each input
signal using the MEMORY function. The saved
settings can be restored whenever necessary. The
items in the PIC CONTROL and PIC SIZE menus can
be memorized. You can save the picture settings of up
to twenty input signals. You can name the settings of
the items (up to 10 characters in length).
Storing the Current Setting
1
Press MENU.
The main menu appears on the display panel.
ENTER MENU
M A I N M E N U
I N P U T S E L E C T
P I C C O N T R O L
P I C S I Z E
C O N F I G
M E M O R Y
R E M O T E
S T A T U S
S E L E C T S E T E N D
2
Press v / V to move the cursor (B) to
“MEMORY” and press ENTER.
The MEMORY menu appears on the display
panel.
ENTER MENU
M E M O R Y
L O A D
S A V E
S E L E C T S E T E N D
Adjusting the Pixels / Using the Memory Function
4
You can adjust the dot phase and the total number
of horizontal pixels automatically or manually.
Adjusting automatically
(1) Select AUTO with v / V and press ENTER.
The following menu appears on the display
panel.
ENTER MENU
P I X E L A D J U S T
A U T O : N O
S E L E C T S E T E N D
(2) Select YES with v / V and press ENTER.
The dot phase and the total number of
horizontal pixels are adjusted automatically.
Adjusting manually
(1) Select DOT PHASE or TOTAL H PIXEL
with v / V and press ENTER.
The following menu appears on the display
panel. (The illustration below is for selecting
DOT PHASE.)
D O T P H A S E : 5 0
(2) Adjust the dot phase or the total number of
horizontal pixels with v / V and press
ENTER.
To restore PIXEL ADJUST menu items to their
original settings
In the PIXEL ADJUST menu, press v / V to move the
cursor (B) to “RESET” and press ENTER. Then
select YES with v / V and press ENTER.