Sony PFM-42B2H - Manual (Page 87)

35
(GB)
6
Press ENTER, then press v / V to move the cursor
(B) to “NAME SET” and press ENTER again.
The following menu appears on the display panel.
ENTER MENU
S A V E / N o . 0 1 [ · · · · · · · · · · ]
N A M E S E T : [ ü V v b B · fHfV% . : ]
S E L E C T S E T E N D
7
Select the character to be changed with v / V and
press ENTER.
The background of a character in the character list
changes to cyan.
8
Select a character in the character list with v / V
and press ENTER.
The selected character is input.
9
Repeat steps 7 and 8 until you finish inputting the
name, then press MENU.
The menu returns to the SAVE menu.
Note
If the storing of the setting fails, the “SAVE ERROR”
message appears on the display panel. Try to store the
setting again.
Calling Up a Stored Setting
1
In the MEMORY menu, press v / V to move the
cursor (B) to “LOAD” and press ENTER.
The first page of the stored settings appears on the
display panel.
ENTER MENU
L O A D / N o . 0 1 [ · · · · · · · · · · ]
- R G B / fH 3 1 . 5 kHz / fV 5 9 . 9 Hz / P O L [ N / N ] -
C O N T R A S T : 8 0
B R I G H T N E S S : 0 0
C O L O R T E M P : H I G H
H S I Z E : 0 0
H S H I F T : 0 0
V S I Z E : 0 0
V S H I F T : 0 0
A S P E C T : 4 X 3
Z O O M : X 1
S E L E C T V E R I F Y E N D
Using the Memory Function
Character list
3
Press v / V to move the cursor (B) to “SAVE”
and press ENTER.
The following menu appears on the display panel.
ENTER MENU
S A V E / N o . 0 1 [ · · · · · · · · · · ]
- R G B / fH 3 1 . 5 kHz / fV 5 9 . 9 Hz / P O L [ N / N ] -
S A V E E X E C U T E
N A M E S E T
S E L E C T S E T E N D
If there is no data in the selected memory number,
the “– – EMPTY – –” message appears on the
display panel in cyan. The signal type and the
color system or horizontal/vertical frequency are
displayed in cyan (showing that the signal type of
the selected memory number is the same as that of
the current setting) or in yellow (showing that the
signal type of the selected memory number is not
the same as that of the current setting).
4
Select a memory number (01 to 20) with v / V
and press ENTER.
The cursor (B) appears on the display panel.
5
Press v / V to move the cursor (B) to “SAVE
EXECUTE” and press ENTER.
The current data is stored under the selected
memory number. The “SAVE COMPLETED”
message appears and flashes for about five
seconds.
When you name the setting, follow the steps
below.
Signal type Color system or horizontal/
vertical frequency
Memory number Setting name