Sony PFM-42B2H - Manual (Page 94)

42
(GB)
On Timer Function (PFM-42B2/
42B2E only)
1
When the Step 4 screen in the ON/OFF TIMER
function is displayed, select ON with v / V and
press ENTER.
The following menu appears on the display panel.
ENTER MENU
O N / O F F T I M E R : O N
O N T I M E : 0 0 : 0 0
O F F T I M E : - - : - -
S E L E C T A D J U S T E N D
T I M E R M O D E : O N
2
Press v / V to select “ON TIME” and press
ENTER.
The following menu appears on the display panel.
The area behind the hour is displayed in cyan.
ENTER MENU
O N / O F F T I M E R : O N
O N T I M E : 1 6 : 3 0
S E L E C T S E T E N D
3
Press v / V to set the hour and press ENTER.
The time is entered and the area behind the minute
is displayed in cyan.
4
Press v / V to set the minute and press ENTER.
If the system turns off the power and goes into the
standby mode, the ON indicator flashes.
Off Timer Function (PFM-42B2/
42B2E only)
1
When the Step 4 screen in the ON/OFF TIMER
function is displayed, select OFF with v / V and
press ENTER.
Controlling Power On/Off Automatically (Power Control Function)
The following menu appears on the display panel.
ENTER MENU
O N / O F F T I M E R : O N
O N T I M E : - - : - -
O F F T I M E : 0 0 : 0 0
S E L E C T A D J U S T E N D
T I M E R M O D E : O F F
2
Press v / V to select “OFF TIME” and press
ENTER.
The following menu appears on the display panel.
The area behind the hour is displayed in cyan.
ENTER MENU
O N / O F F T I M E R : O N
O F F T I M E : 2 0 : 0 0
S E L E C T S E T E N D
3
Press v / V to set the hour and press ENTER.
The time is entered and the area behind the minute
is displayed in cyan.
4
Press v / V to set the minute and press ENTER.
The display unit changes to the wait mode when
the power-off timer turns off.
Notes
• The power saving function does not work when the
signal is input from the VIDEO connectors.
• If the sync signal is not connected to the 13th pin of
the RGB/YUV (D-sub 15-pin) connector in the
INPUT1 or INPUT2 connectors, the display unit
does not turn on even if the sync signal is input. Be
sure to set POWER SAVING to OFF when only an
RGB signal is connected.
• The power saving function, on/off timer function and
power off function in the PIC INVERSION mode
cannot be used simultaneously. When one of those
functions is set to ON (YES), “– – – –” appears next
to the others and their functions are not available.
• If you set ON TIME and OFF TIME to the same
time, the setting of ON TIME takes priority over that
of OFF TIME. The display unit does not turn off at
the OFF TIME.
• The power saving function does not work when the
YUV(component) signal is input.