Using the sleep timer, Deactivating the buttons on the unit, Unit – Sony BDV-E2100 User Manual

Page 42: Controlling your tv with the, Supplied remote control

Advertising
background image

42

US

BDV-E6100/BDV-E4100/BDV-E3100/BDV-E2100

4-446-733-12(1)

D:\NORM'S JOB\SONY HA\SO130060\BDV-E6100_4100_3100_E2100
(PMRF 06)\4446733121_US (U2)\080OTH.fm

masterpage: Left

7

Press RETURN.

The system returns to the previous
display.

8

Press

V/v to select [Test Tone], then

press .

9

Press

V/v to select [Off], then press

.

The test tone signals are not output from the
HDMI (OUT) jack.

To adjust the volume of all the speakers at one
time, press VOL +/–.

Using the Sleep Timer

You can set the system to turn off at a
preset time, so you can fall asleep listening
to music. The time can be preset in intervals
of 10 minutes.

Press SLEEP.

Each time you press SLEEP, the minutes
display (the remaining time) in the front
panel display changes by 10 minutes.

When you set the sleep timer, the
remaining time appears every 5 minutes.
When the remaining time is less than
2 minutes, “SLEEP” flashes in the front
panel display.

To check the remaining
time

Press SLEEP once.

To change the remaining
time

Press SLEEP repeatedly.

Deactivating the
Buttons on the Unit

(Child Lock)

You can deactivate the buttons on the unit
(except for "/1) for preventing
misoperation, such as child mischief.

Hold down x on the unit for more
than 5 seconds.

“LOCKED” appears in the front panel
display.
The child lock function is activated and the
buttons on the unit are locked. (You can
operate the system by using the remote
control.)
To cancel, hold down x for more than
5 seconds until “UNLOCK” appears in the
front panel display.

If you operate the buttons on the unit while the
child lock function is on, “LOCKED” flashes in
the front panel display.

Controlling Your TV
with the Supplied
Remote Control

By adjusting the remote control signal, you
can control your TV with the supplied
remote control.

When you replace the batteries of the remote
control, the code number may reset to the default
(SONY) setting. Set the appropriate code number
again.

Note

Tip

Note

Note

Advertising
This manual is related to the following products: