Network settings – Sony BDV-E2100 User Manual

Page 51

Advertising
background image

51

US

BDV-E6100/BDV-E4100/BDV-E3100/BDV-E2100

4-446-733-12(1)

D:\NORM'S JOB\SONY HA\SO130060\BDV-E6100_4100_3100_E2100
(PMRF 06)\4446733121_US (U2)\090SET.fm

masterpage: Right

Set

ting
s

an

d Ad

just

men

ts

x [System Information]
You can display the system’s software
version information and the MAC address.

x [Software License Information]
You can display the Software License
Information.

[Network Settings]

x [Internet Settings]
Connect the system to the network
beforehand. For details, see “Step 3:
Preparing for Network Connection”
(page 21).

[Wired Setup]: Select this when you
connect to a broadband router using a LAN
cable.
[Wireless Setup(built-in)]: Select this when
you use the built-in wireless LAN of the
system for wireless network connection.

For further details, visit the following website and
check the FAQ:
http://www.sony.com/blurayhtsupport/

x [Network Connection Status]
Displays the current network connection
status.

x [Network Connection
Diagnostics]
You can run the network diagnostic to
check if the network connection has been
made properly.

x [Connection Server Settings]
Sets whether or not to display the
connected DLNA server.

x [Renderer Options]
[Auto Access Permission]: Sets whether or
not to allow automatic access from a newly
detected DLNA controller.
[Smart Select]: Allows a Sony DLNA
controller to find the system as the target
equipment to operate by using the infrared
ray. You can set this function to on or off.
[Renderer Name]: Displays the system’s
name as it is listed on other DLNA devices
on the network.

x [Renderer Access Control]
Sets whether or not to accept commands
from DLNA controllers.

x [PARTY Auto Start]
[On]: Starts a PARTY or joins an existing
PARTY at the request of a networked
device compatible with the PARTY
STREAMING function.
[Off]: Off.

x [Registered Remote Devices]
Displays a list of your registered remote
devices.

To use this function, be sure to perform the
software update (page 46).

x [Remote Start]
[On]: Allows turn on the system by a
device linked via network when the system
is in standby mode.
[Off]: The system cannot be turned on by a
device linked via network.

Tip

Note

Advertising
This manual is related to the following products: