Sony AC-LS5K - Manual

WARNING
To prevent fire or shock hazard, do not expose the product to rain or
moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
NOTICE FOR THE CUSTOMERS IN THE U.S.A. AND CANADA
This symbol is intended to alert the user to the presence of
uninsulated “Dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
The Graphical Symbols with Supplemental Making is located on the bottom
of the product.
NOTICE FOR THE CUSTOMERS IN THE U.S.A.
CAUTION
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
NOTE
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
NOTICE FOR THE CUSTOMERS IN THE UNITED KINGDOM
A moulded plug complying with BS 1363 is fitted to this equipment for
your safety and convenience.
Should the fuse in the plug supplied need to be replaced, a fuse of the
same rating as the supplied one and approved by ASTA or BSI to BS
1362, (i.e., marked with
or mark) must be used.
If the plug supplied with this equipment has a detachable fuse cover, be
sure to attach the fuse cover after you change the fuse. Never use the
plug without the fuse cover. If you should lose the fuse cover, please
contact your nearest Sony service station.
AC Adaptor
Operating Instructions
Manual de instrucciones
Mode d’emploi
使用说明书
AC-LS5K
© 2005 Sony Corporation Printed in Japan
Owner’s Record
The model and serial numbers are located on the AC Adaptor. Record
the serial number in the space provided below. Refer to these numbers
whenever you call upon your Sony dealer regarding this product.
Model No. AC-LS5
Serial No.
Thank you for purchasing the Sony AC Adaptor.
Before operating the product, please read this manual thoroughly and
retain it for future reference.
WARNING
To prevent fire or shock hazard, do not expose the product to rain or
moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
AC-LS5 can be used as follows
AC-LS5 is a 4.2 V output AC Adaptor. You can use a home power supply
(wall outlet) by this adaptor to operate the digital still camera or charge a
battery pack in a digital still camera with a built-in charging function.
Notes on Use
This product does not have dust-proof, splash-proof or water-proof
specifications.
Warranty for Recorded Content
Recording contents cannot be compensated if shooting or playback is not
made due to a malfunction of this product.
Others
• The negligible amount of electric current will flow into the AC Adaptor as
long as the AC Adaptor is plugged into the wall outlet.
• Unplug the product from the wall outlet if it will not be used for a long
time. To disconnect the cord, pull it out by the plug. Never pull the cord
itself.
• Do not use the AC Adaptor placed in a narrow space, such as between a
wall and furniture.
• Do not operate the product with a damaged cord or if it has been dropped
or damaged.
• Do not apply mechanical shock to or drop the product.
• Use this product near a wall outlet. This is to ensure that the power plug
can be immediately unplugged from the wall outlet to power off if some
abnormality occurs during use.
• The nameplate indicating operating voltage, power consumption, etc. is
located on the AC Adaptor.
• Be sure that nothing metallic comes into contact with the metal parts of
the product or connecting cord. If it does, a short may occur and the
product may be damaged.
• Always keep the metal contacts clean.
• Do not disassemble or convert the product.
• While the product is in use, it gets warm. But this is normal.
• Keep the product away from AM radio tunes, because it will disturb AM
reception.
• Do not place the product in a location where it is:
– Extremely hot or cold
– Dusty or dirty
– Very humid
– Vibrating
• Placing this product in locations subject to the direct sunlight such as on
dashboards or near heat-producing devices may cause this product to
deform or malfunction.
If any difficulty should arise, unplug the product and contact your nearest
Sony dealer.
Specifications
AC Adaptor AC-LS5
Input rating
100 - 240 V AC 50/60 Hz
Output rating 4.2 V DC
Operating temperature 0 °C to +40 °C (+32 °F to +104 °F)
Storage temperature –20 °C to +60 °C (–4 °F to +140 °F)
Dimensions Approx. 48 Ч 29 Ч 81 mm (w/h/d)
(1 15/16 Ч 1 3/16 Ч 3 1/4 in.)
Mass Approx. 130 g (5 oz.)
* See the label on the AC Adaptor for other specifications.
Included items
AC Adaptor (AC-LS5) (1)
AC Power cord (1)
Connecting cord (DK-2AA) (1)
Set of printed documentation
Design and specifications are subject to change without notice.
To use this product abroad
You can use this product in any country or region.
Use a commercially available AC plug adaptor (not supplied), if necessary,
depending on the design of the wall outlet.
Do not connect the AC Adaptor to a voltage adaptor (travel converter)
for overseas travel. This may result in overheating or other malfunction.
English Español
Muchas gracias por la adquisición de este adaptador de ca Sony.
Antes de utilizar el producto, lea detenidamente este manual, y consérvelo
para futuras referencias.
ADVERTENCIA
Para evitar incendios o descargas eléctricas, no exponga el producto a la
lluvia ni a la humedad.
Para evitar incendios o descargas eléctricas, no abra la unidad.
En caso de avería, solicite los servicios de personal cualificado solamente.
Nombre del producto: Adaptador de ca
Modelo: AC-LS5
El AC-LS5 podrá utilizarse de la
forma siguiente
El AC-LS5 es un adaptador de ca con una salida de 4,2 V. Usted podrá
utilizar la fuente de alimentación de su hogar (tomacorriente de la red) para
alimentar con este adaptador una cámara digital o cargar la batería de una
cámara digital con función de carga incorporada.
Notas sobre la utilización
Este producto no posee especificaciones de resistencia al polvo, a las
salpicaduras, ni al agua.
Garantía del contenido grabado
El contenido de la grabación no podrá compensarse si la grabación o la
reproducción no se realizan debido al mal funcionamiento de este producto.
Otros
• Mientras el adaptador de alimentación de ca esté enchufado en un
tomacorriente de la red, a través del mismo fluirá una pequeña corriente
eléctrica.
• Cuando no vaya a utilizar el producto durante mucho tiempo,
desconéctelo del tomacorriente de la red. Para desconectar el cable de
alimentación, tire del enchufe. No tire nunca del propio cable.
• No utilice el adaptador de ca en un espacio estrecho, como entre una
pared y un mueble.
• No utilice el producto con un cable de alimentación dañado, después de
haberse caído, ni cuando esté dañado.
• No golpee ni deje caer el producto.
• Utilice este producto cerca de un tomacorriente de la red. Esto es para
asegurarse de poder desenchufarlo inmediatamente de dicho
tomacorriente en caso de que se produzca alguna anormalidad.
• La placa de características, en la que se indica la tensión de alimentación,
el consumo, etc., se encuentra en el adaptador de ca
• Tenga cuidado de que ningún objeto metálico entre en contacto con las
partes metálicas del producto ni con el cable conector. En caso contrario,
podría producirse un cortocircuito, que dañaría el producto.
• Mantenga siempre limpios los contactos metálicos.
• No desarme ni modifique el producto.
• Cuando utilice el producto, se calentará. Sin embargo, esto es normal.
• Mantenga el producto alejado de receptores de AM, porque podría
interferir en la recepción de AM.
• No coloque el producto en un lugar:
– Extremadamente cálido o frío
– Polvoriento o sucio
– Muy húmedo
– Sometido a vibraciones
• Si coloca el producto en lugares sometidos a la luz solar directa, como
sobre el panel de instrumentos, o cerca de aparatos de calefacción, es
posible que se deforme o funcione mal.
En caso de cualquier dificultad, desenchufe la unidad y póngase en
contacto con su proveedor Sony.
Especificaciones
Adaptador de ca AC-LS5
Entrada
ca 100 a 240 V 50/60 Hz 11 W
Salida cc 4,2 V 1,5 A ó 1,7 A
(refiérase a la etiqueta del adaptador suministrado)
Temperatura de funcionamiento
0 a +40 °C
Temperatura de almacenamiento –20 a +60 °C
Dimensiones Aprox. 48 Ч 29 Ч 81 mm (an/al/prf)
Masa Aprox. 130 g
* Con respecto a otras especificaciones, consulte la etiqueta del adaptador
de ca
Elementos incluidos
Adaptador de ca (AC-LS5) (1)
Cable de alimentación de ca (1)
Cable conector (DK-2AA) (1)
Juego de documentación impresa
El diseño y las especificaciones están sujetos a cambio sin previo aviso.
Para utilizar este producto en el extranjero
Usted podrá utilizar este producto en cualquier país o región.
No conecte el adaptador de ca a un adaptador de tensión (convertidor
para viajes) cuando vaya al extranjero. Esto podría resultar en
recalentamiento o mal funcionamiento.
2-586-022-11(1)
Printed on 100% recycled paper using
VOC (Volatile Organic Compound)-free
vegetable oil based ink.
AC Adaptor AC-LS5
Adaptador de ca AC-LS5
DC IN jack cover
Tapón de la tome DC IN
to wall outlet
A un tomacorriente
AC Power cord
Cable de alimentación de
ca
A
B
Connecting cord (DK-2AA)
Cable conector (DK-2AA)
AC Adaptor AC-LS5
Adaptador de ca AC-LS5
AC Power cord
Cable de alimentación
de ca
to wall outlet
A un tomacorriente
Connecting to the Wall Outlet for Use
The procedure for connecting this adaptor differs depending on the type of
your digital still camera.
Connecting the AC Adaptor directly
See illustration A.
1 Open the DC IN jack cover on the digital still camera, and connect
the AC Adaptor to the DC IN jack on the digital still camera.
2 Connect the AC Power cord to the AC Adaptor.
3 Connect the AC Power cord to the wall outlet.
Using the Connecting Cord
See illustration B.
1 Open the battery cover of your digital still camera and insert the
connecting cord (DK-2AA) after confirming it’s direction. Then close
the battery cover.
2 Connect the AC Adaptor to the connecting cord (DK-2AA).
3 Connect the AC Power cord to the AC Adaptor.
4 Connect the AC Power cord to the wall outlet.
Conexión a un tomacorriente de la
red para utilización
El procedimiento para conectar este adaptador diferirá dependiendo del
tipo de su cámara digital.
Conexión directa del adaptador de ca
Consulte la ilustración A.
1 Abra el tapón de la toma DC IN de la cámara digital, y conecte el
adaptador de ca en la toma DC IN de dicha cámara.
2 Conecte el cable de alimentación de ca al adaptador de ca
3 Conecte el cable de alimentación de ca a un tomacorriente de la red.
Utilización del cable conector
Consulte la ilustración B.
1 Abra la tapa de la batería de su cámara digital e inserte el cable
conector (DK-2AA) después de haber confirmado su sentido.
Después cierre la tapa de la batería.
2 Conecte el adaptador de ca al cable conector (DK-2AA).
3 Conecte el cable de alimentación de ca al adaptador de ca
4 Conecte el cable de alimentación de ca a un tomacorriente de la red.
AC-LS5
AC plug adaptor
(not supplied)
Wall outlet
Español