AVerMedia Technologies AverEPack300 - Manual (Page 11)

Chapter 2 Hardware Installation and Setup
7
Connecting AVerEPack300 to the Presentation
Display Unit
Connecting AVerEPack300 to a presentation display unit allows you to display slide
presentation on a television, large LCD projector or even to a VGA monitors
instantly without connecting to PC.
Connecting a VGA Monitor
To display the slide presentation on the VGA monitor, you’ll need to connect
the other end of the VGA monitor signal cable to the “VGA” port at the D-side
panel of AVerEPack300.
Set the DIP switch no. 2 to VGA mode located at the C-side panel of
AVerEPack300 beside the “Power” port.
AVerEPack300 D-Side Panel
VGA Monitor
D
C
B
A
1 2 ON
DIP SWITCH