Sony SAT-T60 - Manual (Page 15)

.

      
         
To select a satellite dish type, press the UP and DOWN navigation arrows to highlight
the type of satellite dish you have. Note that as you highlight the different satellite dish
types, the picture on the right side of the screen changes. To see the next screen,
highlight the type of satellite dish you are using, then press SELECT.
/
* Use the number keys on your remote control to enter your zip code. The
Receiver uses your zip code to determine the direction your satellite dish should point.
Press SELECT to see the next screen.
!!




 Based on your ZIP code and dish type, this screen shows
roughly how to position your satellite dish. You will fine tune the position later on
during Satellite Dish Guided Setup at the
 
!!

$
! $ screen.
Before positioning the dish, be sure the mast (the pole on which the dish is mounted) is
straight up and down. For 2 satellite or 3 satellite dishes, the screen provides a required
tilt in addition to side-to-side (azimuth) and up-down (elevation) information available
for round satellite dishes. Professional satellite installers are available in most areas to
ensure correct installation. If your satellite system was installed by a professional, the
satellite dish direction should be correct. To see the next screen, press SELECT.
!!

 
"!
The items on this list help ensure you receive a clear satellite
signal. To see the next screen, press SELECT when you are satisfied that each item is
complete.
93
&
   
 93
:
   
 ( 
0)  ,/#81
SONY COMBO 2 VG.book Page 4 Friday, December 1, 2000 12:05 PM