Sony MDS-JE440 - Manual (Page 30)

30
masterpage:L0-Left filename[\\Win-35\logitecmo\422958711MDSJE640CED\01GB03OPE-CED.fm]
Before you start editing
model name1[MDS-JE640] model name2[MDS-JE440]
[4-229-587-11(1)]
Editing
Recorded
MDs
This chapter explains how to edit the
tracks that have been recorded to an
MD.
Before you start editing
The buttons and control below are used to erase, divide,
move, or combine tracks on the MD.
Note
The operation of these buttons and the control is different when
naming a track or MD. For details, see “Naming a track or MD”
on page 35.
MENU/NO button: While the deck is stopped, playing,
or paused, press to edit tracks. While editing, press to
cancel editing.
AMS control: Turn to select an editing operation or
track number, then press to enter your selection. You can
also use the control to specify points in a track for erasure
or track division.
YES button: Press this button instead of the AMS
control to enter a selection.
m/M buttons: Press to specify the unit (minute,
second, or frame) by which the MD is advanced when the
AMS control is turned. You can also use these buttons to
locate the end point of the portion to be erased.
For further details on the function of each button and
control, see the following sections on editing operations.
When “Protected” appears while editing
The record-protect slot is open. To edit the MD, slide the
tab to close the slot. For details, see “To prevent accidental
erasure of the recorded material” on page 14.
Brief descriptions of buttons and control
used to edit MDs
About indication which appears while
editing
AMS
MENU/NO YES
AMS m/M