Sony DSC-HX400V - Manual (Page 117)

The GPS function is turned off.
The status icon on the screen may differ depending on the conditions of the signals emitted
from the satellites.
No icon is displayed:
[GPS On/Off] is set to [Off].
The product cannot find a GPS signal, therefore, it cannot acquire the location information. Use
the product in an open area.
The product is searching for GPS satellites. It may take some time to start triangulating.
The product can acquire the current location information.
An error occurred with the GPS function. Turn off the product, and turn it on again.
To receive a GPS signal
Proper triangulation is not possible indoors or near tall buildings. Use the product in an open
area outside, and turn the product off and on again.
It may take from ten seconds to several minutes to acquire the location information.
You can shorten the time of triangulation by using the GPS assist data.
Note
It may take from ten seconds to several minutes to acquire the location information when you
turn on this product. If you shoot images before the product acquires the location information,
the information is not recorded on the images. To record a correct location information, first
make sure the product receives the GPS signal, then shoot the images.
During take off and landing of an airplane, set [Airplane Mode] to [On].
Use GPS in accordance with the regulations of the countries or regions where you use the
product.
How to Use Changing settings Setup menu
GPS Auto Time Cor. (DSC-HX400V)
The product acquires the time information using GPS while the product is turned on, and the
107