Troubleshooting – Sony SDM-S205K User Manual

Page 6

Advertising
background image

6

(US)

Troubleshooting

Trouble symptoms and remedies (If no picture
appears on the screen)

If no picture appears on the screen, check the following table for possible solutions. If you are
experiencing difficulties not listed below, refer to the Operating Instructions on the supplied
CD-ROM. For problems caused by a computer or other equipment, refer to the user’s manuals
supplied with the respective items.

Symptom

Check these items

If the 1 (power)
indicator is not lit, or
if the 1 (power)
indicator will not
light up when the 1
(power) switch is
pressed,

• Check that the power cord is properly connected.
• Check that the display’s MAIN POWER switch is on.

If the 1 (power)
indicator turns on in
red,

• Check that the 1 (power) switch is on.

If “CABLE
DISCONNECTED”
appears on the
screen,

• Check that the video signal cable is properly connected and

all plugs are firmly seated in their sockets (page 4 (US)).

• Check that the video input connector’s pins are not bent or

pushed in.

• Check that the input select setting is correct (For details, refer

to the Operating Instructions on the supplied CD-ROM).

• A non-supplied video signal cable is connected. If you

connect a non-supplied video signal cable, “CABLE
DISCONNECTED” may appear on the screen. This is not a
malfunction.

“NO INPUT
SIGNAL” warning
message appears on
the screen, or 1
(power) indicator
turns orange,

• Check that the video signal cable is properly connected and

all plugs are firmly seated in their sockets (page 4 (US)).

• Check that the video input connector’s pins are not bent or

pushed in.

• Check that the input select setting is correct (For details, refer

to the Operating Instructions on the supplied CD-ROM).

x Problem caused by a computer or other equipment

connected, and not caused by the display

• The computer is in the power saving mode. Try pressing any

key on the keyboard or moving the mouse.

• Check that your graphics board is installed properly.
• Check that the computer’s power is on.
• Restart the computer.

Advertising
This manual is related to the following products: