Sony XA-CC1 - Manual

3-257-674-11 (1)
Operating Instructions
Connection Adapter
 2003 Sony Corporation Printed in Japan
XA-CC1
Features
The XA-CC1 is a connection adapter for connecting a car cradle to a Sony master unit having the CD/
MD changer control function.
Car Cradle Ready Sony car audio units are ;
• Units with CD/MD Changer Control from 2003 forward
• Following units
MEX-5DI,CDX-MP70, CDX-MP30,CDX-M730,CDX-M630,CDX-CA900X,CDX-CA720X,
CDX-CA700X,CDX-CA705M,XR-CA630X,XR-CA430X
Specifications
Power requirement 12 V DC negative ground
Dimensions Approx. 97.2 Ч 55.7 Ч 23.7 mm
( 3 7 /
8
Ч 2 1 /
4
Ч 15 /
16
in.)
(w/h/d)
(not including connection cable)
Mass Approx. 260 g (10 oz.)
(including connection cable)
Input Car cradle I/O input (8pin)
Output SONY-BUS control output (8pins)
SONY-BUS audio output (RCA-pin)
ATT control output
Design and specifications are subject to change without notice.
Installation
Before installation
•Choose the installation location carefully so that the unit does not interfere with normal driving
operations.
•Avoid installing the unit where it would be subject to :
— high temperatures, such as from direct sunlight or hot air from the heater.
— draft, rain or moisture.
— dust or dirt.
— magnetic fields.
•Install the unit at a to location that does not obstruct the operation of passenger-side airbag.
Installation location
Install the unit inside the car panel or glove box is recommended.
Please consult qualified technician or service personnel if you cannot attach the connection adapter to
the car securely.
If you have any questions or problems concerning your unit that are
not covered in this manual, please consult your nearest Sony dealer.
Contents of this manual are printed on chlorine-free
paper using VOC (Volatile Organic Compound)-free
vegetable-oil-based ink.