Sony SAT-T60 - Manual (Page 28)

28 Programming Your Remote Control
3 Highlight and select your TV brand using the
/ / / /SELECT buttons.
The available codes for your TV brand appear.
4 E nter the Remote Control code.
a)Cover the IR emitter on the front end of the Remote Control. This
prevents the Remote Control from operating your Satellite Receiver
while you program the Remote Control.
b)Press and hold the TiVo and POWER/TV buttons at the same time
until the Remote Active indicator lights (about three seconds), then
release the buttons. The indicator remains lit.
c)Use the number keys to enter one of the four-digit codes listed for your
TV brand. The indicator flashes three times, indicating that you
entered the code correctly.
d)Test the code by aiming your Remote Control at the TV and pressing
the POWER/TV button. If the TV turns off, you have programmed the
correct code.
e)If the Remote Control did not turn off your TV, repeat steps 4a through
4d and try the next code listed for your TV.
FPO
Television Brand
Press SELECT to choose your TV brand and continue.
SEARS
SHARP
SIEMENS
SIGNATURE
SONY
SOUNDESIGN
FPO
Codes for SONY
Possible codes for this device are:
Program your TV PWR, VOL, and MUTE
buttons: Point the PTV Remote away
from the Recorder and hold down the
TV PWR and TIVO buttons on the
Remote for 5 sec. Enter the first code
using the numbers on the Remote.
Test the TV PWR button. If it doesn't
work, try the next code.
0043, 0067, 0075, 0117, 0130, 0136, 0170
POWER
9 8 7
6 5 4
SELECT
1 2 3
0
T V
SAT
POWER/TV MUTING
TiVo
Button
Note
If you connected an audio system to
your Satellite Receiver, you can
program the Remote Control’s
POWER/TV, VOL (volume) and
MUTING buttons to operate your audio
system rather than your TV. In step 2c
on the previous page, select “Remote
A/V Stereo System”, and continue the
procedure.