Sony SAT-T60 - Manual (Page 29)

29 Programming Your Remote Control
A
ddi
tio
n
a
l
In
for
m
a
tio
n
Code Search Method
The Remote Control has hundreds of available codes. The correct code for your
TV might be available, even if it is not listed for your TV brand in the on-screen
Code Entry method.
1 Set the Remote Control to Code Search mode.
a)Press and hold the TiVo and POWER/TV buttons at the same time
until the Remote Active indicator lights (about three seconds), then
release the buttons. The indicator remains lit.
b)Using the number keys on the Remote Control, enter 0999.
2 Test the code.
a)Aim the Remote Control at the TV, press POWER/TV and see if the TV
turns off or on.
b)If the TV does turn off and on, press MUTING and VOL (volume) +/–
to make sure they operate the TV. If these buttons operate the TV, go to
step 4 below.
3 Press the CH (channel) + button to cycle to the next
code, then test the code by repeating step 2 above.
The Remote Control has hundreds of available codes. If the Remote
Active indicator goes out, you have tested all of the codes.
4 Press ENTER to set the code and exit Code Search
mode.
Press CLEAR to exit Code Search mode without setting a new code.
Notes
• The Code Search method automatically
programs the POWER/TV, VOL +/–,
and MUTING buttons on the Remote
Control.
• If you have an audio system connected
to the Satellite Receiver, you can
program the POWER/TV button on the
Remote Control to turn on and off both
the audio system and your TV. To do
so, use code 1999 instead of 0999 in step
1b.
• To reset the Remote Control back to the
manufacturer’s settings, enter code
0981 in step 1b.