Sony VGC-RA810G User Manual

Page 200

Advertising
background image

Your new hard disk drive is supplied with the necessary screws. Do not overtighten these screws when securing

the drive to the drive holder.

9.

Align the drive holder with the tracks on the inside of the chassis. Slide the drive holder in completely.

10. Push the drive holder handle down to lock the drive into position.

11. Connect the second drive connector to the new drive. Orient the connector to align pin 1 on the red side of the

ribbon cable with pin 1 on the new drive.

12. Connect the second power connector to the new drive following the instructions supplied with the drive.

Replacing the driv e holder

13. Replace the side panel. See

About Closing the Computer

.

14. Reconnect the power cord to your computer.

Page 200

Advertising