Setup and connections, 1. unpacking – Sony SAT-HD300 User Manual

Page 20

Advertising
background image

19

3. SETUP AND CONNECTIONS

3-1. Unpacking

DIRECTV

®

HD Receiver

The DIRECTV HD Receiver is capable of receiving signals from the satellite dish, cable, and/or over-the-air
antenna and sending the decoder signals to your TV.

Remote Control
In addition to the DIRECTV HD Receiver, the remote control can be programmed to control many other
devices.

Batteries
To install the batteries, slide open the battery compartment and insert the two AA batteries provided.

Component Out Jacks and Cables
Component Cables are used to connect the DIRECTV HD Receiver to an industry standard Y/Pb/Pr compat-
ible Monitor.

DVI-HDTV port and Cable
DVI cable is used to connect the DIRECTV HD Receiver to a DVI-HDTV compatible HD monitor.

S-Video Jack and Cable
An S-Video jack is provided on the DIRECTV HD Receiver and is used together with audio cables.
Remember to connect the left and right audio cables. An S-Video jack carries only the picture signals, not
the sound.

Audio/Video Jacks and Cables
The Audio/Video jacks provide good picture and sound quality. They are used for making most Audio/Video
connections between components. The Audio/Video jacks may be color coded (yellow for video, red for
right audio, and white for left audio). If your component has only one input for audio (mono), connect it to
the left (white L/mono) audio jack on the DIRECTV HD Receiver.

RF (Radio Frequency) Jacks and Coaxial Cables (F-type)
RF jacks are necessary for reception of over-the-air broadcasts, cable, and DIRECTV signals. These jacks
are also required for antenna or cable connections. The RF and coaxial jacks on the DIRECTV HD Receiver
are labeled Antenna, Cable, Satellite and OUT TO TV. An RG-6 type coaxial cable is required for satellite
signal distribution.

Telephone Jack and Cord
A telephone line cord is required to connect the DIRECTV HD Receiver to a phone line. If you choose to sub-
scribe to DIRECTV

®

programming, this phone line is required to be connected.

Access Card
The Access Card is the means by which DIRECTV controls the distribution of its service. The card must be
inserted into the access card slot (on the front of the DIRECTV HD Receiver) at all times to ensure recep-
tion of satellite signals.

Remote Control RF Antenna
The Remote Control RF Antenna can be used with the supplied remote control.

VCR Controller
The VCR Controller allows the Record function to automatically operate your VCR.

Advertising