Sony SAT-HD300 - Manual (Page 27)

26
3-4. Connecting to Antennas - Oval Dish (Satellite A, B, C)
Receiving Signals
1. Connect the “Antenna” to the “ANT IN” jack on the DIRECTV ® HD Receiver using a coaxial RF cable.
2. Connect the cable TV signal to the “CABLE IN” jack on the DIRECTV HD Receiver using a coaxial RF cable.
3. Connect the “Jack 1” of the multi-switch to the “SATELLITE IN” jack on the DIRECTV HD Receiver using a
coaxial RF cable. (For proper dish installation, refer to the “Installer’s Guide” provided with your satellite dish
antenna.)
4. Connect the “Phone Wall Jack” to “PHONE JACK” on the DIRECTV HD Receiver using a phone cable.
(1080i/720p/480p) (1080i/720p/480p)
RGB OUT
DATA PORT
DVI-HDTV OUT
SATELLITE
IN
TYPE
CABLE IN
ANT IN
OUT TO TV
Y
COMPONENT OUT
(1080ii/720p/480p/480ii)
Pr
1
L2
R2 R1
L1
2
AUDIO OUT
Pb
OPTICAL
DIGITAL
AUDIO
OUT S VIDEO
OUT
VCR
CONTROL
RF
REMOTE
(1080ii/720p/480p/480ii)
PHONE
JACK
VIDEO OUT
Phone wall jack
LNB
Sat B LNB
Sat C LNB
Sat A
Dish
5x4 Multi-switch*
Output
Antenna
Cable TV
wall jack
NOTE
While you are subscribing to a DIRECTV ® program-
ming package, you can still view over-the-air and
cable TV programs, if you make connections to the
over-the-air and/or cable jacks.
NOTE
A triple LNB multi-satellite dish with a SAT
C LNB is required to receive all DIRECTV ®
High-Definition programming, along with
this DIRECTV HD Receiver.
* Sat C may also be connected via a SAT B/SAT C combiner with a 4x4 multi-switch (not supplied by Sony).