Connecting the ac power cord, Setting the voltage selector, Performing initial setup operations – Sony STR-DE898 User Manual
Page 17
Getting Star
ted
masterpage:Right
lename[D:\Sony
SEM\Data_DE898_Revision3\J9050152_2580791113DE898U\2580791113\GB03CON_STR-
DE898-U.fm]
17
GB
model name1[STR-DE898]
[2-580-791-11(3)]
Setting the voltage selector
If your receiver has a voltage selector on the rear
panel, check that the voltage selector is set to the
local power supply voltage. If not, use a
screwdriver to set the selector to the correct
position before connecting the AC power cord to
a wall outlet.
Connecting the AC power
cord
Connect the AC power cord to a wall outlet.
* Except for models of area code AR.
The configuration, shape and number of AC outlets
vary according to the area code.
Notes
• The AC OUTLET(s) on the rear of the receiver is a
switched outlet, which supplies power to the
connected component only while the receiver is
turned on.
• Make sure that the total power consumption of the
component(s) connected to the receiver’s AC
OUTLET(s) does not exceed the wattage stated on
the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons,
fans, or TVs to this outlet. This may cause a
malfunction.
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure.
This procedure can also be used to return
settings you have made to their factory defaults.
Use the buttons on the receiver for the operation.
1
Press
?/1
to turn off the receiver.
2
Hold down
?/1
for 5 seconds.
“PUSH ENTER” flashes in the display.
3
Press ENTER.
“MEMORY CLEARING” appears in the
display for a while, then “MEMORY
CLEARED” appears.
The following are reset to their factory
settings.
• All settings in the SPEAKER SET UP,
LEVEL, EQUALIZER and
CUSTOMIZE menus.
• The sound field memorized for each
input and preset station.
• All sound field parameters.
• All preset stations.
• All index names for inputs and preset
stations.
• MASTER VOLUME –/+ is set to
“VOLUME MIN”.
• Input is set to DVD.
4: Connecting the AC
power cord
120V
220V
240V
VOLTAGE SELECTOR
AC OUTLET
ONT B
ONT A
L
L
+
–
UND BACK
ROUND
L
L
+
–
AC OUTLET
*
b
To a wall
outlet
AC power cord
GB01COV_STR-DE898-U.book Page 17 Tuesday, March 15, 2005 12:20 PM