Playing cds getting started getting started, Hookups, Connecting the ac power cord – Sony CDP-CX235 User Manual

Page 5

Advertising
background image

5

Playing CDs

Getting Started

Getting Started

ANALOG OUT

L

R

INPUT

CD

L

R

Hookups

When connecting the audio cord, be sure to match the
color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.

CD player

Amplifier

• If you have a digital component such as a digital

amplifier, D/A converter, DAT or MD

Connect the component via the DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.

POC-15

Optical cable (not supplied)

CD player

Digital component

Note

When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software
other than music, such as a CD-ROM.

If you have a Sony component with the CONTROL
A1 jack

Connect the component via the CONTROL A1

jack.

You can simplify the operation of audio systems
composed of separate Sony components. For details, refer
to the supplementary “CONTROL A1

Control System”

instructions.

When using another Sony CD player together with

this player

You can make the supplied remote effective only for this
player.
• When using the player equipped with the

COMMAND MODE selector:
Set the COMMAND MODE selector of this player to
CD 1 and that of another player to CD 2 or CD 3. Then
set the CD 1/2/3 switch on the remote supplied for
each player accordingly.

• When using the player not equipped with the

COMMAND MODE selector:
The command mode of the player without the
COMMAND MODE selector is set to CD 1. Set the
COMMAND MODE selector of this player to CD 2,
and set the CD 1/2/3 switch on the remote to CD 2.

Setting the voltage selector (voltage
selector equipped models only)

Check that the voltage selector on the rear panel of the
player is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
before connecting the AC power cord to a wall outlet.

Connecting the AC power cord

Connect the AC power cord to a wall outlet.

Note on placement

Be sure to place the player on a horizontal place.
If the player is slanted, it may cause malfunction or
damage the player.

220 - 240 V

110 - 120 V

DIGITAL OUT

OPTICAL

DIGITAL INPUT

OPTICAL

Advertising