Sony DVP S9000ES - Manual (Page 64)

64
Settings and Adjustments
1
4
7
2
5
8
0
3
6
9
TV/VIDEO
Number
buttons
TV/DVD
switch
VOL
CH
1
4
7
2
5
8
0
3
6
9
By adjusting the remote signal, you can control your TV
or AV receiver (amplifier) with the supplied remote.
Controlling TVs with the remote
1
Slide the TV/DVD switch to TV.
2
Hold down ?/1, and enter your TV’s manufacturer’s
code (see the table) using the number buttons.
Then release ?/1.
Code numbers of controllable TVs
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV.
? /1 (on/standby)
button
Number
buttons
TV/DVD
switch
Controlling Your TV or AV Receiver (Amplifier)
with the Supplied Remote
Manufacturer Code number
Sony (default) 01
Akai 04
AOC 04
Centurion 12
Coronado 03
Curis-Mathes 12
Daytron 12
Emerson 03,04,14
Fisher 11
General Electric 06, 10
Gold Star 03,04,17
Hitachi 02,03
J.C.Penney 04,12
JVC 09
KMC 03
Magnavox 03,08,12
Marantz 04,13
MGA/Mitsubishi 04,12,13,17
NEC 04, 12
Manufacturer Code number
Panasonic 06,19
Philco 03,04
Philips 08
Pioneer 16
Portland 03
Quasar 06,18
Radio Shack 05,14
RCA 04,10
Sampo 12
Sanyo 11
Scott 12
Sears 07,10,11
Sharp 03,05,18
Sylvania 08,12
Teknika 03,08,14
Toshiba 07
Wards 03,04,12
Yorx 12
Zenith 15
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote, the code number
may be reset to the default setting. Reset the appropriate code
number.
Controlling the TV
You can control your TV using the buttons below. When
you set the TV/DVD switch to TV, you can also control
the number, ?/1 and ENTER buttons.
By pressing
? /1
TV/VIDEO*
VOL
CH*
WIDE MODE*
Number buttons
and ENTER
* These buttons also work when the TV/DVD switch is set to
DVD.
Note
Depending on the TV, you may not be able to control your TV or
to use some of the buttons above.
ENTER
You can
Turn the TV on or off
Switch the TV’s input source between
the TV and other input sources
Adjust the volume of the TV
Select the channel of the TV
Switch to or from the wide mode of a
Sony Wide TV.
Select the channel of the TV
ENTER
WIDE MODE
? /1 (on/standby)
button