Sony MDR-EX100IP - Manual

©2012 Sony Corporation
Printed in Thailand
How to use / Utilisation / Utilización Earbuds / Oreillettes / Almohadillas
Volume + *
Volume + *
Volumen + *
Center button
Touche centrale
Botón central
Volume –
Volume –
Volumen –
Microphone
Micro
Micrófono
* There is a tactile dot beside Volume +.
* Vous pouvez remarquer un point tactile à
côté de Volume +.
* Hay un punto táctil al lado de Volumen +.
Note on static electricity
Static electricity accumulated in the body may cause
mild tingling in your ears.
To minimize the effect, wear clothes made from natural
materials.
Compatible iPod/iPhone/iPad models
You can use the unit with only the following models
supporting remote control. Update your iPod, iPhone
or iPad to the latest software before use. In the
Operating Instructions, iPod, iPhone and iPad are
collectively described as “iPod” except in special cases.
 iPod touch (5th generation)
 iPod touch (4th generation)
 iPod touch (3rd generation)
 iPod touch (2nd generation)
 iPod nano (7th generation)
 iPod nano (6th generation)
 iPod nano (5th generation)
 iPod nano (4th generation)
 iPod classic 120GB 160GB (2009)
 iPod shuffle (4th generation)
 iPod shuffle (3rd generation)
 iPhone 5
 iPhone 4S
 iPhone 4
 iPhone 3GS
 iPad (4th generation)
Optional replacement earbuds can be ordered from
your nearest authorized Sony retailer or www.sony.
com.
You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment.
Precautions
High volume may affect your hearing.
For traffic safety, do not use while
driving or cycling.
Install the earbuds firmly. If an earbud
accidentally detaches and is left in your
ear, it may cause injury.
Keep earbuds clean. To clean the
earbuds, wash them with a mild
detergent solution.
Specifications
Headphones
Type: Closed, dynamic
Driver unit: 9 mm, dome type (CCAW adopted)
Power handling capacity: 100 mW (IEC*)
Impedance: 16 Ω at 1 kHz
Sensitivity: 103 dB/mW
Frequency response: 5 Hz – 24,000 Hz
Cord: 1.2 m (47 1 /
4
in), Y-type
Plug: Four-conductor gold-plated L-shaped stereo
mini plug for iPod/iPhone/iPad with remote function
Mass: Approx. 3 g (0.11 oz) without cord
Microphone
Open circuit voltage level: – 42 dB (0 dB=1 V/Pa)
Supplied accessories
Earbuds: SS (red) (2), S (orange) (2), M (green)
(attached to the unit at the factory) (2), L (light blue)
(2) / Cord adjuster (winds cord up to 50 cm) (1)
* IEC = International Electrotechnical Commission
Design and specifications are subject to change
without notice.
English Stereo headphones
Using the Center button
Plays/pauses a track of the connected iPod product
with a single press. Skips to the next track with a
double press. Skips to the previous track with a triple
press. Starts the “VoiceOver*” feature with a long press
(if available).
Press once to answer the call. Press again to end. Hold
down for about two seconds to reject an incoming
call. When you let go, two low beeps confirm the call
was rejected.
* Availability of the “VoiceOver” feature depends on
iPod and its software version.
Note
Be careful not to unintentionally press any buttons
when you carry your iPod with this unit connected.
 iPad (3rd generation)
 iPad 2
 iPad
 iPad mini
On copyright
iPad, iPhone, iPod, iPod classic, iPod nano, iPod
shuffle, and iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries.
“Made for iPod,” “Made for iPhone,” and “Made for
iPad” mean that an electronic accessory has been
designed to connect specifically to iPod, iPhone or
iPad, respectively, and has been certified by the
developer to meet Apple performance standards.
Apple is not responsible for the operation of this
device or its compliance with safety and regulatory
standards.
SS S M L
MDR-EX100iP
Stereo Headphones
Operating Instructions
Mode d’emploi
Manual de instrucciones
4-456-783-12(1)