Advantech UNO-1170E - Manual (Page 35)

27
3.6 Hard Drive installation (UNO-1170E)
The procedure for installing a hard drive into the UNO-1170E is shown as
following step.
1. Remove the power.
2. Unscrew six screws from UNO-1170E indicated below.
3. Remove the rear cover. Please refer to Section 3.1 & 3.2 for the
instruction to open the cover.
4. Take four screws from the rear cover to lose the hard drive bracket.
5. Connect the SATA cable and SATA power cable. Make sure the
cable will not lose. Use the screws in accessory to mount the hard
drive on the hard drive bracket.