Panasonic EH2511 User Manual

Page 4

Advertising
background image

For environmental
protection and recycling
of materials

This pore cleanser contains Nickel-
Metal Hydride (Ni-MH) battery.
Please make sure that the battery
is disposed of at an officially
assigned location if there is one in
your country.

How to remove the built-in
rechargeable battery before
disposal of the pore cleanser

(Fig. 10)

The battery in this pore cleanser is
not intended to be replaced by
consumers. However, the battery
may be replaced at an authorized
service center. The procedure
described below is intended only for
removal of the rechargeable battery
for the purpose of proper disposal.
Always make sure that the battery
have been removed from the pore
cleanser before disposing of it.

1.

Unscrew the screw and remove
the battery cover.

2.

Unlatch the hooks on either
side and pull out from the body
of the appliance.

3.

Cut the red and black lead
wires on either side and further
pull out from the body of the
appliance.

4.

Insert a flat-head screwdriver
into the slot (F

a

) and lift up the

Ni-MH battery.

5.

Remove the Ni-MH battery.

Caution

• Pull out the plug of the Charger

when not in use. Always grasp the
plug while unplugging and never
unplug by pulling the cord.

• Do not cut, damage, or modify the

cord. Do not pull, twist, or bend
the cord with unnecessary force.
Do not place heavy objects on the
cord or allow the cord to get
pinched in between objects. Do
not wind the cord around the
appliance.

• The supply cord of this appliance

can not be replaced; if the cord is
damaged, the appliance should
be discarded.

• Do not use the appliance near

inflammable materials, such as
benzine, paint thinner, sprays, etc.

• Do not use this appliance with a

damaged or broken cup, since
injury may be occurred.

• When using the appliance, take

care to use it only on the nose.
Do not stop at any one point on
the skin.

• Do not use the appliance on

pimples, blemishes, sunburned or
broken skin or any skin inflamma-
tions.

• Do not pass the appliance over

the same point more than three
times if you have sensitive skin.

• Never touch the Charger plug

while your hands are wet.

• Do not place or store the Charger

near water.

• Never reach for Charger that has

fallen into water. Unplug
immediately.

7

Caution during use

When mist is not released,
follow the steps below to
clean the appliance.

(Fig. 7)

1.

Turn the Power Switch off and
insert the pointed end (remove
the cap) of the Cleaning Tool
(F

a

) into the Mist Nozzle for a

few times.

2.

Fill the Water Tank with water.

3.

When both the Mist Switch and
Power Switch are turned on,
block the Mist Nozzle with the
pointed end of the Cleaning
Tool for approximately 10
seconds (while checking to see
if the water in the tank is
bubbling).
- A cotton swab (F

b

) may be

used instead of the Cleaning
Tool.

4.

Drain the water out of the Water
Tank.

• If the mist is not released, repeat

steps 1-4. If the mist is still not
released after repeating steps 1-4,
take the appliance to your dealer
for service.

• Water droplets may sometimes be

found on the appliance. This is
the water that has remained after
inspection and is sanitary.

Cleaning

After using the appliance

(Fig. 8)

• Both the body of the appliance

and the cups can be washed
using water.

1.

Put some water (warm if you
like) in a washbowl.
• Do not use hot water
• Do not use detergent

2.

Remove the suction cup, soak
the Suction Hole (Filter) in the
water, and turn the Power
Switch on to wash for about 15
seconds.

3.

Remove the appliance from the
water. Then, leaving the
appliance switched on for about
30 seconds to allow water to
drain from the main body,
shake the water off.

4.

Empty the Water Tank and
allow it to dry by leaving the
Cap unplugged.

5.

Wipe the body of the appliance
and the reversible cups with
tissues or cotton buds, taking
particular care to thoroughly
wipe the insides of the suction
cup.

Regular maintenance

(Fig. 9)

• Suction Hole (Filter) and Mist

Nozzle
Turn the Power Switch off and
remove any accumulated dirt
using the Cleaning Tool provided.

• Charger

Clean the Charger using a cloth
and soapy water, then dry
thoroughly before resuming use.

• Do not use detergent to avoid the

risk of discolouration, deteriora-
tion, or cracking.

6

EH2511欧州取説 05.01.11 21:34 ページ 6

Advertising