ASTAR ASTAR 27''HDTV - Manual (Page 50)

Caution: Always use a power cable that is properly grounded. Please use the AC cords listed below for
each area.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there i no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4.Consult the dealer or an experienced radio/TV technician for help.
4.5-FCC Class B Radio Frequency Interference Statement
4.4-Compliance
Notice:
1.The changes or modifications not expressly approved by the party responsible for compliance
could void the use's authority to operate the equipment.
2.Shielded interface cables and AC power cord, if any, must be used in order to comply with the
emission limits.
3.The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modification to this equipment. It is the responsibilities of the user to correct such interference.
USA
Canada
Germany
Britain
Japan
UL
CSA
VDE
BASE/BS
Electric Appliance Control Act
www.astarelectronics.com
50