Atmel AT91CAP7X-DK - Manual

The AT91CAP7X-DK development board implements the fixed portion of the AT91CAP7 device as a
microcontroller standard product, tightly coupled to a high-density FPGA that emulates the MP Block.
The boards also include a range of memories and physical interfaces/connectors representing
external system components. This configuration enables parallel hardware/software testing of
the application under development at close to operational speed, with no
penalty for hardware modifications. This enables software development
to proceed in parallel with hardware development, and significantly
reduces the design cycle time, increasing confidence in a right-first-time
system solution.
The AT91CAP7X-DK development board or “kit” is composed of three
associated boards, namely Motherboard, Mezzanine and Memory
Extension to be used jointly in order to develop AT91CAP7 processor
applications.
AT91CAP7X-DK Motherboard
The AT91CAP7X-DK motherboard features the following on-board interfaces:
AT91CAP7X-DK Development Kit
for CAP Customizable Microcontroller
CAP TM CUSTOMIZABLE MICROCONTROLLERS
n ATX power supply connector
n 2x Full-speed Host USB interfaces
n 100-base TX Ethernet PHY with three status
LEDs
n DBGU serial communication port
n 4x analog inputs
n AC97 interface with three 3.5 mm audio jack
connectors (MIC IN, LINE IN, LINE OUT)
n I2S audio codec with two 3.5 mm audio jack
connectors (LINE IN, LINE OUT)
n 2x SD/MMC card slots
n Atmel TWI serial EEPROM
n 1/4 inch TFT LCD VGA interface
n Touch Screen Controller
n Image Sensor expansion connector
n 16 push buttons arranged in a keypad form
n CAN bus interface
n Software controlled Power LED
n 2x general-purpose LEDs
n PIO expansion connectors (PIOA, PIOB, PIOC,
PIOD)
n CAP Mezzanine extension connectors
(2x 320 pins)
n PCI64 form FPGA I/O extension connector
n Custom mezzanine-style FPGA I/O extension
connector
n 3x USB device PHY interfaces with USB B
connectors (FPGA controlled)