Panasonic NN-SD772S - Manual (Page 21)

19
timer feature
note:
1. When each stage finishes, a two-beep
signal sounds. At the end of the pro-
gram, the oven will beep five times.
2. If the oven door is opened during
Stand Time, Kitchen Timer or Delay
Time, the time on the display will con-
tinue to count down.
3. Stand time and Delay start cannot be
programmed before any automatic
Function. This is to prevent the starting
temperature of food from rising before
defrosting or cooking begins. A change
in starting temperature could cause
inaccurate results.
4. The maximum programmable time of
Standing Time, Kitchen Time or Delay
Time is up to 90 minutes.
caution:
if oven lamp is lit while using the timer
feature, the oven is incorrectly pro-
gramed. stop oven immediately and
re-read instructions.
This feature allows you to program the
oven as a kitchen timer. It can also be
used to program a standing time after
cooking is completed and/or to program a
delay start.
to use as a Kitchen timer:
example: to count down 5 minutes.
1.
• Press timer/clock.
2.
• Set time, using Time
Select Dial to 5 minutes.
3. • Press start.
 Time will count
down without oven
operating.
to set stand time:
example: to cook at P6 power for 3
minutes, with stand time of
5 minutes.
1.
• Enter the desired Power
level (see page 11 for
directions).
• Set cooking time,
using Time Select
Dial to 3 minutes.
2.
to set delay start:
example: to delay the start of cooking
for 5 minutes, and cook at P6
power for 3 minutes.
1.
• Enter the desired
Power level (see
page 11 for directions).
• Set cooking time,
using Time Select
Dial.
3.
• Press timer/clock.
2.
• Set delay time, using
Time Select Dial To
5 minutes.
5.
4.
• Press start.
 Delay time will
count down. Then
cooking will start.
Press 5 times
Press 5 times
3.
• Press timer/clock.
4.
• Set stand time, using
Time Select Dial.
5.
• Press start.
 Cooking will start.
After cooking, stand
time will count down
without oven operating.
IP4088_3BE30AP_19_120221 2012-2-21 Jerry 下下14:01 Page 19