Panasonic HC-V250K User Manual
Page 163
- 163 -
This item allows you to use NFC to turn on this unit, establish a remote connection, and configure
the home monitoring settings.
Please refer to page
.
If you set [ON], the LCD monitor turns off when remotely operating this unit with a smartphone (in
Motion Picture Recording Mode or Still Picture Recording Mode) so that power consumption is
reduced.
≥ When the LCD monitor is turned off, you can display the screen by touching it.
≥ If the Wi-Fi connection is turned off, this unit will turn off automatically approximately 30 minutes
later.
This will set/clear the Password to limit the startup of the Wi-Fi setting menu.
By setting the Password, it will prevent erroneous operation, prevent wrongful use of the Wi-Fi
function by third party, and protect the set personal information.
1
Touch [Setup].
2
Touch [INPUT], and enter the Password (6 characters).
≥ After finish entering the Password, touch [Enter].
≥ If the Password has already been set,
is displayed.
≥ For details on how to enter characters, refer to page
.
3
Touch [NEXT].
4
Touch [INPUT], and enter the same Password again.
≥ After finish entering the Password, touch [Enter].
≥ If the Passwords match with each other, a message is displayed.
5
Touch [EXIT].
≥ If you set the Wi-Fi Password, you will need to enter the Password each time you touch [Wi-Fi
Setup] on the Wi-Fi home screen.
≥ When you forget your Wi-Fi Password, perform [Reset Wi-Fi Settings] from the Setup menu. This
will set the Wi-Fi setting to the condition at the time of purchase, and you will be able to use the
Wi-Fi setting menu. (
)
You can change the Wi-Fi setting back to the default condition.
≥ The “LUMIX CLUB” Login ID and Wi-Fi Password are also deleted.
[Start up using NFC]
[ON]/[OFF]
[Home Monitor Connect]
[ECONOMY (Wi-Fi)]
[ON]/[OFF]
[Menu Password]
[Setup]/[Delete]
[Reset Wi-Fi Settings]