Panasonic SC-HC38 - Manual (Page 4)

4
RQT9742
Control reference guide
1 Standby/on switch [Í/I] (Í)
Press to switch the unit from on to standby mode or
vice versa.
In standby mode, the unit is still consuming a small
amount of power.
2 Select the audio source
On the remote control
[iPod]: “IPOD_DOCK”
,. “IPOD_PORT”
[CD/RADIO]: “CD” ,. “FM”
[ ]: “BLUETOOTH”
On this unit:
“CD”
-. “FM” -. “BLUETOOTH” -. “IPOD_DOCK”
^--------------------- “IPOD_PORT” (----------------b
3 Basic playback control buttons
4 Enter setup menu
5 Enter the iPod ® /iPhone ® menu /
Change displayed information
6 Open or close the sliding door
7 Adjust the volume (0 (min) to 50 (max))
8 Mute the sound
Mutes the sound. Press again to cancel.
“MUTE” is also canceled when the volume is adjusted
or the unit is turned off.
9 Enter playback menu
10 Enter sound menu
11 Selection/OK
12 “IPOD_PORT” for iPod/iPhone/iPad ® (l 6)
13 Dynamic Bass sound effect selector
14 Power on indicator
15 Display
16 Sliding door
17 Remote control signal sensor
Distance:
Within approx. 7 m (23 ft) directly in front.
≥ To avoid interference, please do not put any objects
in front of signal sensor.
Unless otherwise indicated, operations are
described using the remote control.
SELECTOR
iPad
12
13 6 7 3 2 1 6
14
15 16
17
CD/
RADIO
Top view
∫ Before using for the first time
Remove the insulation sheet A.
∫ To replace a button-type battery
Battery type: CR2025 (Lithium battery)
≥ Set the button-type battery with its (i) mark
facing upward.
≥ Keep the button-type battery out of reach of
children to prevent swallowing.

 
SC-HC38~RQT9742.book Page 4 Tuesday, December 11, 2012 2:20 PM