Panasonic SC-HC38 - Manual (Page 6)

6
RQT9742
Inserting media
*1: Refer to “Playable media” for compatible models.
( l 14)
*2: When using the “IPOD_PORT” connection, do not
connect the following models to this unit:
– iPod classic
® , iPod [4th (color display), and
5th (video) generation]
Unexpected behavior may occur.
*3: When using the “IPOD_DOCK” connection:
≥ Be sure to remove the iPod/iPhone from its case.
≥ Do not push or pull the dock manually.
≥ Make sure that the iPod/iPhone is fully inserted and
its back is resting against the cushion pad.
≥ Make sure to hold the dock when removing the iPod/
iPhone.
*4: Make sure to tilt the disc so as not to touch the sliding
door.
≥ Do not open the sliding door manually.
≥ Make sure that the unit does not fall when inserting or
removing media.
≥ When moving this unit, be sure to remove all media and
turn this unit to standby mode.
Charging starts when an iPod* 2 /iPhone/iPad is
connected to this unit.
≥ During standby mode, charging will not start from the
“IPOD_PORT” connection, however it will start as usual
from the “IPOD_DOCK” connection.
– To charge from the “IPOD_PORT” connection, start
the charging before turning this unit to standby mode.
≥ Check the iPod/iPhone/iPad to see if the battery is fully
charged. (Once fully recharged, additional recharging
will not occur.)
≥ If this unit is switched to standby mode
“IPOD CHARGING” is shown on the unit’s display.
3
4
iPad
Select “IPOD_DOCK” as the source
Connect using the Lightning connector *1
Select “IPOD_PORT” as the source
Connect using the dedicated
USB cable (not supplied) *1, 2
Select “CD” as the source
Charging an iPod/iPhone/iPad
SC-HC38~RQT9742.book Page 6 Tuesday, December 11, 2012 2:20 PM