Auerswald 2500 - Manual (Page 156)

Configuration of the Telephone
Key Programming
156
input field opens where you can enter a 20-digit telephone number. Then the current setting
is shown on the display.
[project number]
Press the
softkey in front of the setting. If there is a list of project numbers available, it
opens and the requested project number can be selected by pressing the softkey in front
of the selection. Otherwise an input field opens where you can enter a 2- to 6-digit project
number. Then the current setting is shown on the display.
[name]
Press the
softkey in front of the setting. If there is a list of names available (e.g. configu-
rations available in the PBX), it opens and the requested name can be selected by pressing
the softkey in front of the selection. Otherwise an input field opens where you can enter a
16-character name with the keypad. Then the current setting is shown on the display.
[switching type]
The current setting is shown on the display. Press the
softkey in front of the setting to
switch between from on, off and over.
If you have configured a key with switch over, you can switch on or off the corresponding
function with each key pressing. If you have programmed a key with switch on or off, you can
only switch the corresponding function on or off.
[operation]
The current setting is shown on the display. Press the
softkey in front of the setting to
switch between log in, -out and -over.
If you have configured a group key with log over, you can log the telephone in and -out with
each key pressing. If you have configured a group key with log in or -out, you can only log
the telephone in or out.
[direction]
The current setting is shown on the display. Press the
softkey in front of the setting to
switch between inbound, outbound and inbound & outbound.
[execution type]
The current setting is shown on the display. Press the
softkey in front of the setting to
switch between “hold the key” and “switch over key”.
[mailbox type]
The current setting is shown on the display. Press the
softkey in front of the setting to
alternate between global mailbox and individual mailbox. The quantity of necessary settings
changes at the same time.
[door function]
The current setting is shown on the display. Press the
softkey in front of the setting to
switch between open the door and/or switch the light on and/or door terminal call.
[subscriber]
Press the
softkey in front of the setting. If there is a list of subscriber telephone numbers/
names available, this will open and the requested subscriber can be selected by pressing the
softkey in front of the selection. Then the current setting is shown on the display.
[remote access code]
Press the
softkey in front of the setting. An entry field opens to enter a 4-digit remote
access code via the keypad. The current setting is not shown on the display.