Auerswald 2500 - Manual (Page 167)

Configuration of the Telephone
Signalling
167
Configure/change the User PIN
39
You can delete the PIN by not entering any PIN in both menus but by only pressing the
softkey.
Signalling
Configure LED Signalling for Messages
In the idle state the LED near the message key shows the condition of the caller list:
ț LED flashes: In the list are new entries that have not yet been viewed.
ț LED glows: There are no new entries. All the entries in the list have been read but not
deleted.
If you like to deactivate the glowing LED you can switch it off as follows.
39
Only available when operated on the PBX systems COMpact 2204 USB, COMpact 2206 USB, COM-
pact 4406 DSL, COMpact 4410 USB and COMmander Basic.
Open the settings menu for the setting “User
PIN” (You will find help on
page 33 and the fol-
lowing).
settings
blocking
User PIN
N
******
Enter the PIN.
Press the softkey to complete the entry.
N
******
Re-enter the PIN.
Press the softkey to complete the entry.
☞
Advice
Open the settings menu for the setting “mes-
sage LED” (You will find help on
page 33 and
the following).
settings
signalling
message LED