Auerswald 2500 - Manual (Page 168)

Configuration of the Telephone
Signalling
168
Configure LED and Tone Signalling for Call Waiting
In this menu can be set whether an inbound call will be signalled during a call by a tone and/
or a LED or only via display message.
Configure Attention Tone for Waiting Field and Power Dialling
In case of existing calls, additional inbound exchange line calls to the Waiting Field are sig-
nalled by an attention tone and flashing LEDs (
page 144 ). As soon as a subscriber called with
Power Dialling is not been busy anymore ( page 60 ), the system telephone activates the loud-
speaker and signals this with an attention tone, too. If you are disturbed by the attention tone,
you can switch it off. The volume of the attention tone depends on the configured ringer vol-
ume.
The icon marks the current
setting.
Use the and softkeys to browse to the
option you require and press the softkey to
the left of the option:
ț flashing + on: Switch on the LED signalling.
ț flashing only: Switch on the restricted LED
signalling.
ț LED always off: Switch off the LED signal-
ling.
...
Open the settings menu for the setting “call
waiting tone” (You will find help on
page 33
and the following).
settings
signalling
call wait.tone
The icon marks an activated
selection.
The icon
marks a deacti-
vated selection.
Press the or softkey to the left of the
option you require to reverse the actual status.
ț LED: Activate/deactivate the LED signalling
above the hook key.
ț tone: Activate/deactivate the acoustic sig-
nalling.
Press the softkey to complete the settings.
...
...