Chapter, Tel 2500), Internal number – Auerswald 2500 User Manual
Page 17
Introduction
First Use of the Telephone
17
The individual configuration of the telephone, the settings of the freely programmable func-
tion keys as well as the operation of other functions is done via the main menu after pressing
the menu key (see
).
Connection and Mounting of the Key Extension COMfortel Xtension30 (COMfortel 2500)
Before you re-assemble, disconnect the telephone from the PBX and (if already existing) the
wall-mount power supply from the 230-V mains power.
Exchange of the wall-mount power supply may be dangerous to life or may damage or
destroy the device.
–
Use only the enclosed wall-mount power supply unit COMfortel XT-PS (type number
809).
To use one or more key extension modules COMfortel Xtension30 with the telephone, you
will need the wall-mount power supply COMfortel XT-PS (type number 809).
The key extension modules can be attached to the right or left side of the telephone (on the
the modules have been attached to the left side next to the receiver). A
connection to both sides is not possible.
The installation material (an special connector with four screws) as well as the connection
cable (RJ-11 to RJ-10) is enclosed with each key extension module.
Connect the key expansion module to the telephone as follows:
1.
Turn the telephone and the first key extension module to be connected topside down so
that the bottom side is in front of you. Put it together with help of the special connector as
shown on
(in the picture the modules have been attached to the left
side next to the receiver).
2.
Attach the special connector with help of the four enclosed screws.
3.
Insert the smaller plug of the connection cable into the jack marked with
on the bot-
tom side of the telephone.
4.
Insert the larger plug of the connection cable into the jack marked with
on the bottom
side of the key extension module.
5.
If you like to connect additional key extension modules (up to three are possible), attach
them to the already connected module with help of the special connector and fasten each
special connector with the screws.
6.
Insert the smaller plug of the connection cable into the jack marked with
on the bot-
tom side of the already connected key extension module.
7.
Insert the larger plug of the connection cable into the jack marked with
on the bottom
side of the next key extension module.
N
internal number
Enter the internal telephone number.
Press the
softkey to complete the entry.
The telephone is now ready for
use (If the PBX does not known
the date and time yet, the
name and version of the tele-
phone is displayed here).
[
]
☞
Advice
Warning
☞
Advice