ATTO Technology 3400 User Manual
ATTO Technology Computer Accessories
Advertising
ATTO FibreCenter™ 3400
Secure Data Path Application
Installation and Operation Manual
© 2002 ATTO Technology, Inc. All rights reserved. All brand or product names are trademarks of their respective
holders. No part of this manual may be reproduced in any form or by any means without the express written
permission of ATTO Technology, Inc.
5/02 Document Control Number: PRMA-0320-000
Advertising
Table of contents
Document Outline
- 1 Fibre Channel is a key technology for storage
- 2 ATTO FibreCenter supports diverse SAN needs
- 3 ATTO FibreCenter 3400 characteristics
- 4 Setting up the FC Rack System
- 5 Setting up the ATTO FibreCenter
- 6 Configuring the ATTO FibreCenter
- Data transfer when setting up zones
- FibreCenter behavior on reset or power-up
- Zone 1
- Zone 2 and Zone 3
- Exhibit 6-1 Single zone configuration (Zone 1), an eight-port hub configuration. Ports 2, 3, 4, ...
- Exhibit 6-2 Dual-zone configuration (Zone 2 and Zone 3) as designated by the Setup and Switch co...
- 7 Command Line Interface use and guidance
- 7.1 Ethernet and Telnet configuration commands
- 7.2 Diagnostic commands
- 7.3 Configuration commands
- 8 Updating firmware
- 9 Troubleshooting
- Index: Command Line Interface
- Appendix A Standards and compliances
- Appendix B Contact ATTO Technology, Inc.