Balboa Water Group ColorGlo LED Multi-Color Bath Lights User Manual

Colorglo ™ led multi-color bath lights, Danger, Risk of electrical shock or electrocution

Advertising
background image

40663 Rev A July 28, 2009

ColorGlo

LED Multi-Color Bath Lights

DANGER

Risk of Electrical Shock or
Electrocution

Always disconnect power to the bath light
at the circuit breaker before servicing the
light. Failure to do so could result in death or
serious injury to the installer, bath users, or
others due to electrical shock.

Choosing Lighting Modes

The ColorGlo™ LED Multi-Color
Bath Light comes pre-programmed
with 10 exciting lighting modes.

To advance to the next lighting

mode, switch the unit off
and then on again within five
seconds.
To resume a lighting mode,

leave the unit switched off to
store the last lighting mode
displayed in memory. That
same lighting mode will
display the next time the unit is
switched on.

Safety Precautions

Be sure to follow all instructions

in this user guide and carefully
observe all safety precautions.
Do not attempt to service

the electronic components
yourself. Non-expert handling
may cause injury to the user
and/or damage the unit. Any
opening, altering or tampering
with this product will void the
manufacturer’s warranty.
Do not submerge this unit in

water or allow it to get wet.
Keep the unit dry at all times.
Do not allow this unit to freeze.

Always handle this unit

cautiously, being careful to
never drop it.

www.ColorGloProducts.com

ColorGlo™ LED Multi-Color Bath Light offers
a variety of microprocessor controlled lighting
effects that will instantly transform your bath
into a color-rich paradise.

This user guide contains important information
regarding the operation of your LED Bath Light.
Please review the entire guide carefully and save it
for future reference.

Replacing the LED Bath Light and or
Standard 12 Watt Light Bulb

Step 1

Access the currently installed
light/s by removing the center,
clear light lens. Use the tool
provided with your whirlpool to
remove this center lens.

Step 2

Remove the o-ring seal very
carefully. Make sure not to
stretch the o-ring.

Step 3

Remove the light bulb or LED
from the socket in the rear light
reflector housing. To remove
bulb, pull it straight back
towards you.

Do not twist to

remove.

Step 4

Plug the bulb or LED Bath
Light into the socket. Push
the blade connection firmly
into the socket in the reverse
manner to which you removed
the bulb. Make sure the bulb or
LED light is securely installed or
bottomed out.

Step 5

Replace the o-ring very carefully
and reinstall the center light
lens using the same tool you
used to remove it.

Note: Make sure not to over
tighten, crimp or distort the
o-ring when reinstalling the
center light

lens. (See Safety

Precautions)

Operating the LED ColorGlo™
Multi-Color Bath Light

The LED Bath Light is easily
controlled using the bath existing
light switch to turn the unit on and
off.

Lighting Mode Sequence

Magenta

Blue

Red

White

Sunburst

Green

Tidal Wave

Afterburner Fade

Color Burst

Slow Dance

LED Life Rating

Light Emitting Diodes (LEDs)
generate the illumination of the
Bath Light.

The predicted source life of the LED
is rated at 100,000 elapsed time
hours, or 11 years of continuous use,
under normal operating conditions.
The following are considered normal
operating conditions for this multi-
color bath light:

Temperature range of -4° F to

104°F (-20°C to 40°C )
Humidity range of 0% - 95%,

non-condensing

Advertising