Balboa Water Group Ozone to Jet and Suction - Manual

INSTALL OZONE TO JET AND SUCTION
ELECTRICAL CONNECTION (Diagram A)
-Plug pump into piggy back plug on Ozone Generator
-Plug Ozone into switch box
-Connect switch box with ¼” ID tubing to tube side On/Off
air button. Or use optional electronic control
INSTALLATION GUIDE
Connecting the Ozone Generator to the suction side of the pump wet-end:
Option 1 (Reference Master Diagram)
-Drill out one of the 3/8” O.D. nipples on the suction
inlet port using a 3/16” drill bit.
-Connect one end of 3/8” ID tubing to the drilled out
nipple on the suction inlet port. Secure with band type
clamp.
-Connect the other end of 3/8” I. D. tubing to the check
valve barb and secure with wire clamp.
-Arrow on Inline Check MUST face towards the suction
inlet port nipple.
Option 2 (Reference Master Diagram)
-Drill a 3/8” hole in the suction line close to pump.
-Glue a Saddle Barb (Part # 00372 for 2”pipe, or Part # 00375
for 1.5” pipe) using PVC pipe cement on pipe surrounding
hole and area under barb
* DO NOT GLUE OVER HOLE ON BOTTOM OF
SADDLE BARB
-Connect one end of 3/8” I.D. tubing to saddle barb and
secure with wire clamp.
-Connect other end of 3/8” I.D. tubing to the check valve barb
and secure with wire clamp.
-Arrow on Inline Check Valve MUST face towards the 3/8”
saddle barb.
NOTE: DO NOT GLUE TUBING TO BARBS!
Option 1
Option 2
Electrical Connection for Pump and Ozone Generator:
Part #99634 Air Switch Box w/20 min. timer
Part #99620 Electronic control with 20 min. timer
Diagram A
PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLATION
Connecting the Ozone Generator directly to the suction line:
40570 Rev A July 20, 2009