Analog Devices BHD930-AG - Manual (Page 16)

Chapter 2 : STARTING (continued) BROAD SCAN (HD/SDI)
PAGE 16
2-2. SETTINGS
c We recommend resetting the BROAD SCAN to all of its default values, with the front panel display menu
(CONTROLdefault valueyes) before proceeding.
d Select the auto-setting menu with the front panel display menu (INPUTAuto setting) and activate this function
with ENTER. This function detects automatically the input type of the source connected to the input connectors
(DVI & RGB). Then the device performs an auto-centering function.
e Select the Input status menu (INPUTInput status) to verify the correct detection of the type and format of your
input source. If a wrong message is displayed, select manually the type of your input source (INPUTInput
Type).
f Select the output format and rate (OUTPUTFormat).
g For SDTV output format (PAL, NTSC) select the type of the RGB/YCrCb output (OUTPUTType).
2-3. IMAGE ADJUSTMENTS
c Select the UNDER/OVER scan mode with the front panel button.
d Adjust the position & size of the image with the front panel buttons.
e Adjust the level of anti-flicker with the panel display menu (IMAGEFlicker filter).
f Perform the others adjustments, available in the Image menu.
2-4. EMBEDDED AUDIO MODE
The embedded audio menu is available for BHD930 & BSD830 models only. The device allows embedding analog
audio stereo signal into the HD/SD-SDI output signals.
c Connect an analog audio stereo source to the AUDIO IN (L /R) connector.
d Activate the Embedded audio mode with the front panel display menu (AUDIOEmbed.ON).
e Adjust the audio level with the front panel display menu (AUDIOLevel).
f Adjust the audio balance with the front panel display menu (AUDIOBalance).