Advanced Technology MirroFlex Structures - Manual

ATI-MFFII Revision 2 Effective Date: 8/5/12
Advanced Technology, Inc (800) 849-1320 www.advtechnology.com
Page 1 of 6
MirroFlex™ Structures
Fabrication and Installation Instructions
MirroFlex™ Structures are decorated thermoplastic sheets with high impact resistance and are
available in a wide variety of patterns and colors. They can be used as a value-added product in areas
that vertical grade High Pressure Laminates (HPL) are typically used.
General
Sizes - 4’ x 8’ x .032” (1220 x 2440 x .8 mm). MirroFlex Structures are also available as 2’ x 2’ and
2’ x 4’ Lay-in (grid) ceilings tiles; 2’ x 2’ and 2’ x 4’ Glue-up tiles; 18” x 24” Backsplash tiles; and 30”-
32” x 48” Wainscot tiles.
Most product ships with clear protective film or with TuffCote™.
Slight imperfections and color variations from sheet to sheet are possible and considered normal.
Please inspect each sheet carefully before fabrication to insure it meets your needs.
Storing
Store flat and acclimatize in the same environment for at least 24 hours before fabrication.
Cutting/Fabricating
MirroFlex™ Structures can easily be cut to size with razor knife and scissors or with routers, saw
blades, and drilling tools for thermoplastics. When fabricating MirroFlex always cut from the
decorated side.
Lamination
Like HPL, Structures sheets can be bonded with contact cement, but you must use a product
compatible with PVC.
Cleaning and Care
Clean only with warm soapy water. Never use abrasive cleaners.
Molding
Molding is available to join and finish Structures sheets. Inside corners, outside corners, edge trim
and universal trim strips are shown below.
Trims available in 4’ or 8’ lengths.