American Bicycle Security Company SR Series - Manual

Product SR
Capacity SR-15: 15 bikes
SR-30: 30 Bikes
Size SR-15: 15’ Long
SR-30: 30’ Long
Materials *Reference these numbers when viewing diagram below.
1. Bike Rack Frame – QTY. 1
2. Support Frame – QTY. 2
3. Connector Bracket – QTY. 10
4. Pipe Rail – QTY. 2
5. Pipe Support – QTY. 2
Finishes An after fabrication hot dipped galvanized finish is our standard
option.
Our powder coat finish assures a high level of adhesion
and durability by following these steps:
1. Sandblast
2. Epoxy primer electrostatically applied
3. Final thick TGIC polyester powder coat
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
www.ameribike.com
Email: [email protected]
SR Rack
ASSEMBLY INSTRUCTIONS
Attach bike rack frame to
support frame to
support frame using
supplied set screws.
Slide the pipe support
brackets on to the
pipe rails and place in the
center of rail.
Make sure the assembly is
square and
plumb and tighten all
bolts.
Place in proper location
and bolt to
surface using hardware
supplied by others.