American Electric Lighting 875 new - Manual

INSTALLATION & MAINTENANCE INSTRUCTIONS
875 SERIES SIGN LIGHTER
American Electric Lighting a division of Acuity Lighting Group, Inc. Conyers, GA
DRAWING NO. B62071 REV B (FRONT) ©2003 ACUITY LIGHTING GROUP, INC. PART NUMBER 057-70-62071
WARNING
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.
HOUSING MUST BE GROUNDED TO REDUCE POTENTIAL OF ELECTRICAL SHOCK
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL
AND LOCAL ELECTRICAL/BUILDING CODES. FOR CODE INTERPRETATION, CONSULT LOCAL CODE AUTHORITY.
BEFORE INSTALLING VERIFY THAT THE SUPPLY VOLTAGE MATCHES THAT REQUIRED BY THE FIXTURE
AS SPECIFIED ON THE DATA LABEL.
CAUTION
!
!
TENON
TENON
BRACKET
ASSEMBLY
SET
SCREWS (4)
KNUCKLE
BOLT
SET
SCREWS (6)
ILLUSTRATION "C"
ILLUSTRATION "B"
ILLUSTRATION "A"
FIXED POSITON TENON MOUNT
FIXTURE AIMING IS NOT ADJUSTABLE. THE TENON
MOUNT WILL SLIP FIT ONTO A 1 1/2" PIPE. TIGHTEN
SET SCREWS. SEE ILLUSTRATION "C"
ADJUSTABLE TENON MOUNT
THE TENON MOUNT WILL SLIP FIT ONTO A 2" OR
2 1/2" PIPE. LOOSEN TENON FITTER KNUCKLE BOLT
AND ROTATE TO DESIRED ANGLE. TIGHTEN KNUCKLE
BOLT AND SET SCREWS. SEE ILLUSTRATION "B"
CHANNEL MOUNT
FIXTURE AIMING IS NOT ADJUSTABLE. THE CHANNEL
MOUNTING BRACKET ASSEMBLY IS RECOMMENDED FOR
USE WHEN MOUNTING TO SIGN STRUCTURE OUTRIGGERS
CONSISTING OF 1 5/8" X 1 5/8" CHANNEL. PLACE
FIXTURE (WITH BRACKET ASSEMBLY ATTACHED) ONTO
CHANNEL AND ALIGN THE SLOTS IN THE BRACKETS
WITH THE SLOTS IN THE CHANNEL. ATTACH BRACKETS
TO CHANNELS BY INSTALLING FOUR EACH OF THE
FOLLOWING:
A #3/8 - 16 X 1 1/2" BOLT, A #3/8 WASHER, A
#3/8 LOCK WASHER, AND A #3/8 RETAINING SPRING
TYPE NUT. TIGHTEN ALL BOLTS SECURELY.
(HARDWARE IS NOT PROVIDED).
SEE ILLUSTRATION "A"
MOUNTING OPTIONS