Beijer Electronics CAN J1939 EN - Manual

Cable Connection
The pins for the CAN connection are used according to the description below.
Settings in the Configuration Tool
Double-click on the Peripherals folder in the Project Manager in the configuration
tool for the operator panel.
Right-click on Expansion Port and select Fieldbus. Then drag Controller 1 or
Controller 2 with the corresponding driver to the Fieldbus icon. To change the se-
lected driver, select Properties from the Project menu.
For further information, please see the information for the driver.
Pin Description
1 Not used
2 Connection to CAN High
3 Connection to CAN Low
4 Not used
5 Connection to CAN Shield
Note:
The last user on the CAN bus must be terminated with R120
Ω .
1 2 3 4 5
Expansion Module for CAN J1939
Installation
MAEN962 2009-02 English