Changing the drive rollers (cont.) – Hawk Industries Spinner Manual 550 HYDRAULIC Serial Numbers 206 to 591 User Manual

Page 26

Advertising
background image

26

Maintenance & Repair

2. Use the 3/4" wrench to remove

all Bearing Cap Bolts (47).

3. Remove the Bearing Caps (1)

and Bearing Seals (29).

4. Slide out the Drive Roller

Sprockets (2).

5. Remove the Drive Roller Snap

Rings (27).

6. Remove the Drive Rollers (11)

and Keys (9).

7. Slide on the new Drive Rollers

and replace the Keys (9).

8. Replace the Drive Roller Snap

Rings (27).

9. Slide in the Drive Roller

Sprockets (2) . Make sure the

"T"(stamped) on each Drive

Roller Sprocket faces up.

10. Replace the Bearing Caps (1)

and Bearing Seals (29).

11. Use the 3/4" wrench to replace

all Bearing Cap Bolts (47). Use
new Lock Washers (41) and red
loctite when replacing the
Bearing Cap Bolts (47).
Assemble
the Lock Washers
(41) as shown. Torque Bearing
Cap Bolts (47) to 75 lb. ft.

Part Numbers

Part Name

Part #

Bearing Cap Bolt (47) 999-806373

Lock Washers (41)

031-91074A033

Drive Roller (11)

031-24649

Bearing Seal (29)

031-24654

WARNING

Replace all four Drive Rollers.

Running the Spinner with worn

Drive Rollers will damage the

chain and hinder Spinner

performance.

NOTE

Replace the Drive Sprocket and

Drive Roller Sprockets if the

Chain Continues to wear out

prematurely.

Changing the Drive Rollers (cont.)

Advertising