Hawk Industries Spinner Manual 550 HYDRAULIC Serial Numbers 206 to 591 - Manual (Page 29)

29 Maintenance & Repair
Changing Rear Pivot Assembly
Tools Required
Two 1 1/2" wrenchs, Hammer,
Punch.
Changing Rear Pivot Assembly
1. Set Spinmaster on a flat surface.
2. Use the two 1 1/2" wrenchs to
remove Pivot Bolt (32)
3. Remove two pivot sleeves (5)
from the moving case halve.
4. Pivot the moving case halve
away from the stationary case
halve.
3. Remove two pressed in brass
flange bearings (23) from the
moving case halve.
4. Replace all parts (5,16,23,
32), and reassemble in reverse
Part Numbers
Part Name Part #
Bushing (5) 031-24637
Lock Washer Set (16) 031-91074A038
Flange Bearing (23) 031-24729
Hex Bolt (32) 031-91268A935
Changing All Other
Spinmaster Parts
1. See Drawings, p.48-54.