Martin Universal Design Avanti Print Rack Assembly - Manual

Print Rack Assembly Instructions
- [2] Each Base Feet A
- [4] Angled Legs B
- [2] Cross Members C
- [4] Flat Spindles D
- [4] 2-3/8” Hex Bolts E
- [8] 1-3/4” Hex Bolts F
- [1] Hex Wrench G
Carton Contains
- [1] Material Shelf H
Assembly:
Step 1:
Empty contents of carton. Make sure all parts listed above are
included. If you are missing any part, please call our Customer
Service Dept at: (313)895-0700.
Step2:
Begin by attaching each angled leg (B) to base foot (A). Make
sure oval cut-outs are facing inward.
Push wood into cutout on base and secure by using [1] 2-3/8”
Hex Bolt (F) through bottom of base foot (A). DO NOT Tighten
completely. Repeat with remaining 3 Angled Legs (B).
SEE FIG. 1
FIG. 1
(B) (B)
(A)
(E)
Martin/F. Weber Co.
4444 Lawton Avenue, Detroit, MI 48208 USA