Brocks Performance Clutch Mod R1 (09-13) User Manual

Brocks Performance Voice Recorders

Advertising
background image

DOCUMENT ID 992755

Page 1 of 1

Installation Instructions

Yamaha R1 (09-10) Clutch Mod Kit

This package contains:

1 - Brock’s Performance Clutch-Mod©

Special Note: We recommend the use of a factory service manual for all Brock’s
Performance Product installations and/or maintenance.

A note before you begin: assembly is in EXACT reverse order of disassembly,

unless otherwise noted.

1. Remove clutch cover.

2. Loosen and remove all 6 clutch springs/tops and pressure plate.

3. Loosen clutch inner hub nut. (A special tool is available to hold the hub; we

use a glove to hold the inner hub and remove the nut with an impact gun.)

4. Remove the nut and the three (3) springs, the springs are not re-used.

5. Place the clutch mod onto the shaft with the recess over the clutch hub.

Replace the nut and torque to 85 lb-ft (115 Nm). (The glove and impact
gun trick works here also.)

6. Install the pressure plate and clutch springs.

7. Replace the cover/gasket. Install and torque the bolts to 8.7 lb-ft (12 Nm).

8. Adjust clutch free play per owner’s manual.



LIMITED WARRANTY & LIABILITY DISCLAIMER

Brock Davidson Enterprises, Inc. unconditionally warrants that its parts be free from defects in Materials and Workmanship prior to installation. However,
Brock Davidson Enterprises, Inc. does not make any warranties expressed or implied including without limitation, warrant to fitness, or Merchantability

of any of our products for particular use or purpose due to extreme stress applications to which this product is subjected. All products are for racetrack
use only. Any other use may violate the law. Not all parts are certified for highway use. Check your local

and state laws. Brock Davidson

Enterprises disclaims any an all liability for consequential or incidental damages.

Brock’s Performance Products are designed for Closed-Course Racetrack use ONLY!

For more information go to

www.BrocksPerformance.com,

click: Installation Instructions

email:

[email protected]

or call the office at 937-912-0054

Brock’s Performance Products policies and warranty information:

www.BrocksPerformance.com

, click: Policies

Brock’s Performance Products • 4064 East Patterson Road • Dayton, OH 45430 • Phone: 937-912-0054 • Fax: 937-912-0062

DO NOT RE-USE

Advertising