Rugged Ridge Offroad Jack Roll Bar Mounting Bracket, 92-14 Jeep Wrangler - Manual

Page 1 of 2
11586.02
ROLL BAR OFF ROAD JACK MOUNTING BRACKET
CONTENTS: QTY
1. U-bolt 2
2. Base Bracket 1
3. Beam Bracket 1
4. M8 Flange Nut 4
5. Button Head Bolt 2
6. M12 Wing Nut 3
7. Plastic Retaining Washer 1
BRACKET IS DESIGNED TO WORK HI-LIFT BRAND OFF
ROAD JACKS
1. Install the Base Bracket on the passenger side roll bar. Place
the U-bolt about 5” above where the roll bar meets the body as shown
in the image. Tighten the M8 Flange Nuts making sure the mounting
flange of the bracket remains vertical and facing the driver side roll
bar.
Warning: Make sure when placing U-bolts around the roll bar that
they do not interfere with the seat belts. This will prevent seat belts
from functioning properly.
2. Install the Beam Bracket on the driver side roll bar about 3”
above where the roll bar meats the body. For JK, install this bracket
with the mounting flange facing upward as shown in the image. For
YJ and TJ models, the bracket should be installed with the mounting
flange facing downward. In all cases, be sure the U-bolt does not
interfere with the seat belts, wires or roll bar covers.
3. Place the base of the jack onto the mounting flange of the
passenger side bracket and line up the base holes with the two
mounting holes in the bracket. Slide the bolts through the base of
the jack and through the holes in the bracket and loosely attach the
wing nuts to the backside of the mounting bracket.